Quality 1st Basement Systems Before & After Photos

This customer had a very damp and humid crawlspace that was causing mold to grow and the current insulation to fall down. To start off this project we first removed all the old damp insulation and then treated the mold with our Mold-X2 treatment. Next, we installed our SilverGlo insulation wall panels and sprayed our spray foam insulation. Following our insulation install, we put down our CleanSpace Vapor Barrier, install a SmartPump with Smart Pipe and then we finish up the install with a SaniDry Sedona Dehumidifier. 

This Elkton, MD basement project consisted of 2 SuperSump Pumps an Ultra Sump Battery Back-Up, WaterGuard and CleanSpace Vapor Barrier. Now if any water tries to enter the basement during a rainstorm, this basement is fully protected. The Cleanspace will direct any water or moisture from the wall, down to the Waterguard. Once the water hits the Waterguard it will then flow over to the SuperSump to be pumped out and away from the house. In some cases, there could be a strong storm coming through and it knocks out the power, we got them covered on this as well since we installed an Ultra Sump Battery Back-Up. If and when power goes out, the Ultra Sump will kick on and keep the water flowing out of the basement.

The owner of this restaurant in Elkton, MD reached out to our company looking for help for his wet basement. For as long as his restaurant has been open, he has been getting water in the basement and since the basement always collects water, he could not utilize this large space for much needed storage.

After sending our inspector out to assess this basement, he came up with the best solution to not only keep it dry during rainy weather, but to also make this large basement, a usable space.

This installation consisted of Waterguard and a CleanSpace Vapor Barrier around the full perimeter of the basement, two Triple Safe Sump Pumps with Ultra Sump Battery Back-ups and a Trench Drain. We also removed and hauled away most of the current concrete floor and poured a new concrete pad in its place.

This customer contacted us regarding water leaking in the basement when it rains. We installed our TrenchDrain Drainage Pipe System which is uniquely designed to span doorways, hatchway entrances, and similar entryway doors. Any water passing over the drain is collected through the openings and redirected to a sump pump. This product is flushed, up against the doorway and patched with fresh concrete. 

This Elkton customer contacted us regarding an unfinished basement having water entering in the corner of the cement block foundation, which would increase during rain and snow melt. Our team installed WaterGuard around the perimeter of the basement, which effectively captures wall and floor seepage before it reaches the basement floor. We finished up with our CleanSpace, which is a moisture and vapor barrier that forces wall seepage to flow into the drain system that is around the perimeter.