Concrete Lifting and Leveling Before & After Photos

This slab of concrete on a Marlboro, NJ property was sinking 2-3 inches from the entrance of the pool. Not only was this unpleasant to look at, but it was hazardous for the people using the pool because they could easily trip. Quality 1st Basements was contacted to use PolyLevel on the homeowner's concrete, lifting and leveling it until the pool deck looked good as new.  

Check out this pool deck repair we did in Malboro, NJ. This homeowner planned to close their pool before the summer ended, but before they could do that they needed to repair the sinking concrete. Our System Design Specialist, Andrew G., inspected the pool deck and immediately knew this was a job for the Polylevel Injection. Since Polylevel is also waterproof and had a quick recovery time, it will not be affected by pool water and the homeowner can close their pool within the next day. After the installation was done by our foreman, Sean J., and crew, the pool deck was fully repaired and ready for action. 

Wow! Check out this quick job we completed in Marlboro, NJ to help this homeowner with their settling concrete. As a solution, we used PolyLevel to lift, level and stabilize the concrete patio area. PolyLevel is an environmentally foam that fills the voids between the slab and soil to permanently lift and level the concrete.

A Malboro, NJ homeowner noticed the edge of their pool was sinking. The homeowner needed to get their pool deck repaired and luckily came across a concrete lifting video on Facebook. After a quick phone call, an appointment was booked with  System Design Specialist, Andrew Gagliardi, to go out and provide an estimate for the homeowner. After fully inspecting the pool deck, Andrew knew that the Polylevel System would be the perfect solution to repair the pool. 

Foreman, Sean Johnson, and his crew injected PolyLevel underneath the settling concrete to fill the voids, raise the slab and stabilize the area permanently.  

A property in Wickatunk, NJ had a sinking walkway. Quality 1st Basement Systems injected PolyLEVEL underneath the slab, lifting it up back into place. PolyLEVEL dries in just thirty minutes and is cheaper and cleaner than replacing the concrete.