Quality 1st Basement Systems Before & After Photos

Worsening cracks and sinking slabs around their driveway left a Sewell, NJ homeowner feeling overwhelmed and concerned about long-term damage. The uneven concrete not only created safety hazards but also impacted the overall appearance and usability of the space. Realizing the issue stemmed from ongoing concrete settlement, the homeowner reached out to Quality 1st for a reliable, long-term solution.

After conducting a thorough inspection of the driveway, our team identified soil erosion and voids beneath the slabs as the primary causes of the settlement.

To address the problem, we designed a tailored repair plan using our advanced PolyLevel Foam Injection system. By injecting the high-density foam beneath the sunken sections, we were able to lift and stabilize the concrete back to its original height with minimal disruption. To further protect the surface, we applied NexusPro Joint Sealant, an ultra-durable, UV-resistant material that seals joints and prevents water from seeping below the slabs. The combination of PolyLevel and NexusPro not only restored the driveway's appearance and safety but also ensured long-lasting protection against future settlement!

A homeowner in Jamison, PA noticed their concrete sidewalk was sinking and settling. They called Quality 1st Basement Systems to see if PolyLevel would be the perfect solution. Our Concrete Design Specialist, Joe, performed a free inspection of the entire walkway area and knew that PolyLevel would safely lift and stabilize the entire walkway area. The homeowner's peace of mind was restored once our team removed the trip hazards! 

A Jamison, PA homeowner discovered their concrete patio was sinking a few inches, so they contacted Quality 1st Basement Systems for an estimate. We provided a thorough inspection of the patio and recommended the Polylevel Injection as the best repair solution. Polylevel is a waterproof polyurethane foam that is injected underneath the concrete and lifts the concrete back to its original height. 

System Design Specialist: Joe DelVecchio

This homeowner in Belvidere, New Jersey noticed their walls were cracking and starting to bow inwards. This happens because loose soil after construction creates an active wedge where water can easily flow into it, and create hydrostatic pressure. The homeowner contacted Quality 1st Basement Systems and our System Design Specialist, Jay Alvarez, suggested they use a non-invasive solution to permanently stabilize the walls. Our foreman used the CarbonArmor System which is flexible carbon fiber fabric straps. The fiber straps are bonded to the inner face of the wall to stabilize it.

Check out this basement waterproofing job in Asbury, NJ! We installed our WaterGuard French Drain System and SuperSump Pump System. The homeowner had an old sump pump that was not properly working, so their peace of mind was restored when we installed our sump pump. Take a look at the comparison! Our Sump Pump has an airtight lid to stop moisture from evaporating into the air. This lid protects the sump pump inside the liner as well.