
Weep Holes
We drill weep holes along the bottom of the foundation walls to allow any trapped water to drain into the WaterGuard System. This step helps relieve hydrostatic pressure and ensures moisture doesn't build up behind the walls, keeping the basement dry from the ground up.

During WaterGuard Install
After drilling weep holes, we place our WaterGuard Drainage System just below the floor slab, along the perimeter of the basement. It's then connected to a sump pump, covered with clean washed stone for filtration, and sealed with fresh cement, leaving a clean finish and a permanently dry basement.

SuperSump Premier Install
Our crew installed the SuperSump Premier by carefully excavating a pit at the lowest point of the basement, placing the sump liner, and connecting it to the WaterGuard System. Once the pump was securely in place, we finished the installation with a sealed lid and an airtight discharge line, ensuring powerful, reliable water removal.

WaterGuard Drainage System
WaterGuard offers a clean, effective solution for basement drainage. Installed directly below the floor but above the foundation footing, it captures wall and floor seepage before it reaches the homeowners living space, keeping the basement dry, clean, and protected from water damage.

SuperSump Premier
The SuperSump Premier is more than just a sump pump, it's a complete waterproofing solution. With a powerful 1/3 HP pump, a sturdy liner, an airtight lid, and an optional backup system, it provides dependable, long-term protection against basement flooding and water intrusion.