Weep Holes
We drill weep holes along the basement perimeter before installing WaterGuard to allow trapped water to drain into the system, preventing pressure buildup and ensuring effective moisture control.
During WaterGuard Install
To install our WaterGuard System, we begin by digging a trench along the interior perimeter of the basement floor. We then place the WaterGuard drainage channel just above the footing to collect water seeping from the walls and floor. After connecting it to the sump pump, we cover the system with clean washed stone and apply cement to restore the floor surface.
TripleSafe Install
Installing our TripleSafe Sump Pump starts with excavating a pit at the lowest point of the basement. The TripleSafe liner is placed in the pit, housing three powerful pumps for maximum protection. Once connected to the drainage system and discharge lines, the pit is backfilled and sealed with cement for a clean, finished look.
WaterGuard Drainage System
WaterGuard provides a reliable, clog-resistant way to capture water at the foundation wall-floor joint and direct it to the sump pump, helping keep your basement dry year-round.
TrenchDrain
TrenchDrain is designed to capture surface water at entry points, directing it into your drainage system to prevent water from entering and damaging your basement.
TripleSafe Sump Pump
The TripleSafe Sump Pump offers triple the protection with a primary pump, backup pump, and battery-powered pump to keep your basement dry even during power outages or pump failure.
IceGuard Discharge Line
IceGuard Discharge Line prevents water backup during freezing temperatures by allowing water to escape even if the discharge line is frozen, ensuring your sump pump system continues to protect your basement year-round.
